Range Rover P38 Front Height Sensor. 25 mm (1 in.) below standard. Anr4686 p38 front air suspension height sensor.
2x Ride Height Level Sensor Front Side for Land Rover ebay.com
25 mm (1 in.) below standard. Lift liner for access to height sensor multiplug. Front air suspension left front height sensor suitable for p38 from (v)va345920 vehicles.
ebay.co.uk
65 mm (2.6 in.) below standard. Remove cover from height sensor.
ebay.com
This is for owners of the range rover p38. it is written for those with possibly limited technical experience but reasonably competent at diy tasks. The electronically controlled air suspension (eas) system provides a smoother ride. and allows the selection of different ride heights. either manually or automatically.
ebay.com
N° 2 blocks 105mm rear setting n° 2 blocks 100mm front setting low setting: They look like they use the same 5v/ground/ voltage out as a p38.
ebay.co.uk
Anr4686 p38 front air suspension height sensor. Discussion in range rover started by j l carr. feb 16. 2019.
ebay.co.uk
The internal thermal sensor should cut out at approximately 120 degc. allowing the system to cool down for three minutes. Less than 32 km/h (20 mph). where headroom is.
aliexpress.com
L322 eas height sensor on p38 has anyone tried using a l322 or disco 2 height sensor on a p38 ? Fit cover to height sensor.
The Eas Fault Messages Associated With The Eas Height Sensors. Are The Only Fault Messages That Can Be Taken As Truth.
Remove 2 bolts securing height sensor to. Less than 32 km/h (20 mph). where headroom is. 25 mm (1 in.) below standard.
Remove Cover From Height Sensor.
They look like they use the same 5v/ground/ voltage out as a p38. Front air suspension left front height sensor suitable for p38 from (v)va345920 vehicles. N° 2 blocks 80mm rear setting
65 Mm (2.6 In.) Below Standard.
L322 eas height sensor on p38. Location auckland . new zealand posts 4. Any failure of a sensor will trigger an eas fault.
Range Rover P38 Air Suspension Front Height Sensor Drop Link Genuine Lr Stc2763 (Fits:
When an eas height sensor fault is recorded. it is useful to inspect and clean the wiring harness for that specific height sensor. Collect heat shield mounting bracket and 2. The eas height sensors rarely fail but when they do. will result in very specific eas fault messages.
Discussion In Range Rover Started By J L Carr. Feb 16. 2019.
Results 1 to 8 of 8 thread: Disconnect multiplug and remove height sensor. N° 2 blocks 105mm rear setting n° 2 blocks 100mm front setting low setting: